This kit is designed for Workshops to learn about Arduino, Sensors, Actuators, Coding and Design. It includes a full how-to guide online, and comes with the following:YourDuinoRoboRED Arduino-UNO-compatible with built-in 3-pin I/O connectors, higher-current 5.0V and 3.3V supply.1 x Bluetooth Radio remote interface: connect to Smartphones etc.5 x Big push-button switches [Digital Input]2 x 10K Potentiometers that fit breadboard well [Analog Input]5 x 10K Photo Resistors (Light sensors) [Analog Input]1 x Ultrasonic Distance Sensor [Digital Signal Input]1 x Joystick Module {Analog Input]1 x Digital temperature sensor DS18B20 [Digital Signal Input]1 x LCD Display 2 lines of 16 characters [Signal Output]50 x LEDs - 5 assorted colours, plus 10 220 ohm resistors (below) [Digital or Analog Output]1 x Red-Green-Blue Multicolour LED [Digital or Analog Output]1 x Buzzer Module (makes sound with voltage applied) [Digital Output]1 x Beeper Module (Makes different sounds/tones with Arduino TONE Library) [Analog Output]1 x Servo Motor (Mechanical positioning from digital pulses] [Digital Signal Output]1 x Small Stepper Motor with driver board [Digital Signal Output]1 x DC Motor small 5V1 x Power Transistor NFET (Can control DC motor, other large DC loads)2 x 3-pin cables to 3-pin connectors that fit the Robo1 and various Electronic Bricks etc.2 x 3-pin cable to separate wire ends that connect the Robo1 to any device1 x USB Cable (50cm)1 x 40 wide flat rainbow color cable that can be separated to make many different cables2 x 40 pin strips that can be separated to connect cables to breadboard and other devices10 x 220 ohm resistors (LED current limit etc.) and 10K resistors (switch pullups etc.)1 x 8cm high-quality Breadboard with power and ground strips
