Racks & Stands

Stainless steel. Suitable for test tubes with an external diameter of 25 mm.Can be easily dismantled for cleaning and sterilisation purposes. Dimensions 270 x 70 x 138 mm (L x W x H).

Hardwood complete with base and rod. All parts are interchangeable. Funnel holder is slotted.

Polypropylene, horseshoe funnel holder especially for separating funnels. Supplied with two 'olives' so will fit supporting rod diameters to 14 mm. Cannot be used with funnels below 75 mm diameter.

Adjustable height maximum 290 mm. Aluminium with stainless steel operating screw top plate with 10 mm tapped hole in right rear corner for accepting retort rods. Both plates are anodised.

Adjustable height maximum 290 mm. Aluminium with stainless steel operating screw top plate with 10 mm tapped hole in right rear corner for accepting retort rods. Both plates are anodised.

Hardwood with polypropylene ends.

Hardwood with polypropylene ends.

Hardwood with polypropylene ends.

Hardwood block with 10 holes. Dimensions (L x W x H): 170 x 60 x 25 mm.

A 'Z’ shaped test tube rack made from 18 gauge aluminium sheet, anodised and arranged in three rows. With 5 holes of 23 mm diameter, 6 holes of 20 mm diameter and 8 holes of 13 mm diameter. Overall height of 75 mm and length of 200 mm

Polypropylene test tube racks which are autoclavable and suitable for use in water baths as well as standard bench-top use. Dimensions: 230 mm x 100 mm x 60 mm approx. (L x W x H). Hole diameter 16 mm.

Polypropylene test tube racks which are autoclavable and suitable for use in water baths as well as standard bench-top use. Dimensions: 230 mm x 100 mm x 60 mm approx. (L x W x H). Hole diameter 20 mm.

Polypropylene test tube racks which are autoclavable and suitable for use in water baths as well as standard bench-top use. Dimensions: 230 mm x 100 mm x 60 mm approx. (L x W x H). Hole diameter 25 mm.

Polypropylene test tube racks which are autoclavable and suitable for use in water baths as well as standard bench-top use. Dimensions: 230 mm x 100 mm x 60 mm approx. (L x W x H). Hole diameter 30 mm.

Supports 18 thermometers with protective foam cushion on the base. Dimensions (L x W x H) 165 x 120 x 125 mm.

Epoxy-coated steel wire dual panel draining rack, it can be free standing or used as two wall mounted racks. Contains 122 pegs each peg is 70 mm long arranged as eight rows of ten pegs four each side) and six rows of seven pegs three each side). Dimensions 560 x 580 x 330 mm.

Blue epoxy-coated, steel wire test tube rack, resistant to most solvents, weak acids and bases. Will withstand autoclaving up to 121°C

Blue epoxy-coated, steel wire test tube rack, resistant to most solvents, weak acids and bases. Will withstand autoclaving up to 121°C

Blue epoxy-coated, steel wire test tube rack, resistant to most solvents, weak acids and bases. Will withstand autoclaving up to 121°C